Sliprobot L1 Bedienungsanleitung

User guideBefore using the machine, read this user guide thoroughly and make sure that you have understood it.

10SHARPENING CUTTING LINKSWith manual or automatic shoutdown. The machine can be stopped manually without a stop clamp when sharpening is complete, or

11FOR A DOUBLE LINK, PROCEED AS FOLLOWSSharpen the other (2) (Fig E) of the two links on the same side, double links 2.3.Stop the automatic system wit

12SHARPENING SETTINGSetting the stroke between the cutting links. (Slacken the wingnut and push it to the right for a shorter stroke.)Adjust the cutti

13GRINDING THE DEPTH GAUGE LUGSSet the grinding angle (o° degrees); see under Grinding angle.Install the correct grinding wheel 1 (Fig G) for grindi

14MAINTENANCECHANGING THE GRINDING WHEEL1. Lift up the grinding head (1) and remove the guard (9).2. Hold the grinding wheel (2) and slacken the nut (

15SETTINGS AND SERVICINGIf one cutting link gets too deep or too shallow, this can be changed by slackening screw 1, 2, 3 or 4 and turning motor 5 as

16TROUBLESHOOTINGThe chain is not fixed during sharpening (Fig. I). Tighten M6 nut (1) clockwise about one turn, or more if necessary.The incoming pow

172523222120181716151513121234145611109871924

1812345111213109788

19EC DECLARATION OF CONFORMITYManufacturer:Markusson Development Systems ABTegelbruksvägen762 31 Rimbo, Swedenhereby declares that:Sliprobot L1Logosol

2CONTENTSCONTENTS ... 2GENERAL ...

Basic tips:Cutting angle, see page 8 in the operator's manual. In most cases we recommend to grind at 60 degrees or from 50 to max 75 degrees. Th

3GENERALThis user guide describes in detail how to use, maintain and inspect the chain sharpening machine. It also describes the steps to be taken to

4SYMBOLSBefore using the chain sharpening machine, read this user guide thoroughly and make sure that you have understood it all.Wear eye protection.W

5SAFETY REGULATIONSLocate the machine where it is not exposed to rain or moisture.The site must be well lit.The machine must not be located close to g

6POWER SUPPLYIn order to obtain the best result the machine should be connected to a car battery 12 volt (max 12-14 volt, min 9 ampere).NOTE:Battery p

7Machine operating controls1. Start the motor of the sharpening machine.12. Chain rulers.2. Start the automatic system. 13. Adjusting the grinding ang

8INSTALLING THE SHARPENING MACHINEInstall the machine on a bench or stand.NOTE: The machine must be securely fixed. 1The machine should be mounted so

9CENTRING THE GRINDING WHEELIf the lengths of the right and left cutting links turn out different on sharpening, this can be adjusted with adjusting s